The TI-1000 is a general purpose low cost digital indicator with a NEMA 4x stainless steel enclosure for use in washdown environments. It comes with an oversize (1") LCD screen for easy readout of up to 5,000 display divisions, and supplies enough current for up to 4-350W load cells. The primary and secondary displayed units may be altered to fit the required application. All setup parameters may be entered via the front panel keys, including calibration.
The TI-1000 uses full duplex RS-232 serial format for communication with many types of attached support equipment. The unit can transmit data on demand, or continuously in a popular data protocol to match a wide variety of printers, remote displays, or personal computers. Wiring diagrams to connect extra equipment will be found on page 2 of this manual.
The setup parameters are altered through the Setup menu. A graphical road map of the Setup menu is found on page 3 of the manual. The Configuration section of the manual, found on page 2, explains how to enter the Setup menu. In this mode, the five front panel keys become directional navigators to maneuver and save settings.
ANALOG SPECIFICATIONS
Full Scale Input Signal
Input Impedance
Internal Resolution
Display Resolution
Measurement Rate
System Linearity
Calibration Method
Excitation Voltage
RFI Protection
 |
30V, including dead load
30MW , typical
Approximately 100,000 counts
5,000 dd
10 Meas/sec
Within 0.02% if FS
Software Calibration, with long term storage in EERPROM
+5VDC, 4 x 350W load cells
Signal and excitation lines protected by LC Low
Pass Filter |
DIGITAL SPECIFICATION
|
Microcomputer
Digital Filtering |
Intel 80C32
Program Memory:
SCRAM:
EEPROM:
Software selectable |
.
32K x 8, external to m C
8K x 8, external to m C
64 x 16, external to m C
 |
SERIAL COMMUNICATION
Printer Port
 |
Full duplex at 1200, 2400,
4800, or 9600 Baud. Data bits and parity selectable
 |
OPERATOR INTERFACE
Display
Additional Symbols
Keyboard
 |
1" (25.4mm) 7-segment, Liquid Crystal, 4½ Digit
Net, Gross, kg, neg weight
5-key flat membrane panel |
POWER
AC Adapter
Power Consumption
 |
12 VDC @ 800mA
110mA, with 4 x 350W load Cells |
|
